工业用水与废水2024,Vol.55Issue(5) :88-91.

废油漆桶清洗废水处理工程设计

Engineering design of treatment of wastewater from waste paint buckets cleaning

刘峻 朱亚飞 刘从彬
工业用水与废水2024,Vol.55Issue(5) :88-91.

废油漆桶清洗废水处理工程设计

Engineering design of treatment of wastewater from waste paint buckets cleaning

刘峻 1朱亚飞 1刘从彬2
扫码查看

作者信息

  • 1. 郑州亿众环境科技有限公司,郑州 450006
  • 2. 江苏润环环境科技有限公司河南分公司,郑州 450006
  • 折叠

摘要

根据废油漆桶清洗废水高pH值、高COD和悬浮物、可生化性较差的水质特点,设计采用加酸中和-气浮-混凝沉淀-臭氧氧化-水解酸化-缺氧-好氧-MBR组合工艺进行处理.工程运行结果表明,在进水COD、BOD5、SS质量浓度分别为3 750、900、450 mg/L,色度为420度时,相应出水分别为110、15、5 mg/L和15度,排水水质满足GB/T 19923-2005《城市污水再生利用 工业用水水质》表1规定的洗涤用水标准.该工艺具有运行稳定,操作简单,投资及运行成本低且节约水资源等特点,实现了良好的经济效益和环境效益.

Abstract

According to the characteristics of wastewater from waste paint buckets cleaning such as:high pH value,high COD and SS concentrations,poor biodegradability and so on,a combined process of acid neutral-ization-air flotation-coagulation sedimentation-ozone oxidation-hydrolytic acidification-anoxic-aerobic-MBR was adopted in the design for its treatment.The operation results of the project showed that,when the mass concen-trations of COD,BOD5 and SS in the influent water were 3 750,900 and 450 mg/L respectively,the colority was 420 degree,the relevant indexes of the effluent water were 110,15,5 mg/L and 15 degree respectively.The ef-fluent water quality met the requirement of washing water standard specified in table 1 of GB/Ti 19923-2005 The reuse of urban recycling water-Water quality standard for industrial uses.The said process has characteris-tics of stable operation,easy manipulation,low investment and operation cost,saving water resources and so on,which achieves good economic and environmental benefits.

关键词

废油漆桶清洗废水/臭氧氧化/缺氧-好氧活性污泥法/MBR/气浮/混凝沉淀

Key words

waste paint buckets cleaning wastewater/ozone oxidation/anoxic-aerobic activated sludge pro-cess/MBR/air flotation/coagulation sedimentation

引用本文复制引用

出版年

2024
工业用水与废水
东化工程科技股份有限公司

工业用水与废水

CSTPCD
影响因子:0.649
ISSN:1009-2455
段落导航相关论文