C100机制砂免压蒸管桩混凝土配制技术研究

Research on concrete preparation technology of C100 machine-made sand non-autoclaved pipe pile

高超 ¹陈鹏 ²王晶 ¹卢传泰 ³汤国芳 ³李健 ⁴高麒²

扫码查看

作者信息

1. 中国建筑科学研究院有限公司,北京 100013;建筑安全与环境国家重点实验室,北京 100013;国家建筑工程技术研究中心,北京 100013
2. 江苏诚意桩业科技发展有限公司,江苏徐州 221000
3. 江苏诚意工程技术研究院有限公司,江苏徐州 221000
4. 江苏诚意住宅工业科技发展有限公司,江苏徐州 221131
折叠

摘要

为实现节能低碳的生产工艺,推广应用C100机制砂免压蒸管桩,采用由Ⅰ级粉煤灰、超细粉煤灰、硅灰组成的管桩专用矿物掺合料和机制砂试配免压蒸管桩混凝土,研究了矿物掺合料掺量、胶凝材料总量、水胶比、静停时间、升温速率对管桩混凝土性能的影响.结果表明:通过优化配合比设计参数和蒸养制度配制出适用于开模人工布料方式的免压蒸管桩混凝土,离心成型后内壁质量较好,蒸养脱模、3 d、28 d抗压强度分别超过95 MPa、100 MPa、105 MPa,蒸养脱模、28 d氯离子迁移系数分别低于4×10-12 m2/s、3×10-12 m2/s.

Abstract

In order to realize the production process of energy saving and low carbon,C100 machine-made sand non-autoclaved pipe pile are popularizing and applying.The special mineral admixtures for pipe pile mainly contains Ⅰ fly ash,ultra-fine fly ash,silica fume and machine-made sand were used to test and mix the concrete for non-autoclaved pipe pile.The effects of the mineral admixtures,the total amount of cementitious materials,the water-cement ratio,the static stop time and the heating rate on the performance of the concrete for pipe piles were studied.The results show that the non-autoclaved pipe pile concrete suitable for manual distribution mode of mold opening was prepared by optimizing the mix design parameters and steam curing system,the quality of the inner wall after centrifugal molding is good.The compressive strength of steam curing demoulding,3 d and 28 d exceeds 95 MPa,100 MPa and 105 MPa respectively,and the chloride ion migration coefficient of steam curing demoulding and 28 d is lower than 4×10-12 m2/s、3×10-12 m2/s.

关键词

C100/机制砂免压蒸管桩混凝土/配合比设计/蒸养制度

Key words

C100/machine-made sand non-autoclaved pile concrete/mix design/steam curing system

引用本文复制引用

出版年

2024

混凝土

中国建筑东北设计研究院有限公司

混凝土

CSTPCD北大核心

影响因子：0.844

ISSN：1002-3550

段落导航