首页|含钒四氯化钛精制尾渣锰化焙烧制备V2O5工艺研究

含钒四氯化钛精制尾渣锰化焙烧制备V2O5工艺研究

扫码查看
为探究含钒四氯化钛精制尾渣中钒资源的提取利用可行性,在锰化焙烧提钒过程热力学分析的基础上,采用尾渣水洗预处理—锰化焙烧—草酸浸出—铵盐沉钒的工艺,重点研究了水洗液固比、焙烧温度、碳酸锰添加量对焙烧熟料物相组成和钒浸出率的影响规律.结果表明:粗TiCl4 含钒尾渣采用水洗的预处理方式,可有效降低尾渣中氯的含量,保障后续的铵盐沉钒,提高钒产品品位;适当提高焙烧温度和碳酸锰添加量有助于低价的钒与锰盐生成可溶性焦钒酸锰(Mn2V2O7),但焙烧温度超过 850℃和碳酸锰添加量大于 2.0 时,将导致含钒物相被硅酸盐等液相产物包裹,致使钒浸出率降低.试验适宜条件为:水洗液固比 10 mL/g,碳酸锰添加量(以n(MnO)/n(V2O5)计)2.0、焙烧时间 2 h、焙烧温度 850℃,浸出时间 30 min、浸出温度 50℃.上述条件下钒浸出率达 82.16%,且浸出液经铵盐沉钒—焙烧工序后可得到纯度大于 99%的粉状五氧化二钒产品.该工艺实现了含钒四氯化钛精制尾渣中钒的高效提取和分离,研究结果对该类型尾渣提钒具有指导意义.
Study on the Preparation of V2O5 by Manganization Roasting of Vanadium-containing Tailings from Titanium Tetrachloride Refining Process
In order to investigate feasibility of the extraction and utilization of vanadium resources in the vanadium-con-taining tailings of titanium tetrachloride refining,on the basis of thermodynamic analysis of vanadium extraction by manganese roasting,the process of pretreatment of titanium tetrachloride refining tailings with water washing,manganese roasting,oxalic acid leaching and vanadium ammonium precipitation was adopted,and the influences of the ratio of liquid to solid in water washing,roasting temperature,and the amount of manganese carbonate added on the composition of physical phase of the clink-er and the vanadium leaching rate of the roast were mainly investigated.The results showed that the pretreatment of crude TiCl4 vanadium tailing with water washing can effectively reduce the content of chlorine in the tailing,guarantee the ammonium pre-cipitation of vanadium and improve the grade of vanadium products.Increasing the roasting temperature and the content of man-ganese carbonate appropriately can help the low valence states vanadium and manganese salts to generate soluble manganese pyrovanadate(Mn2V2O7).However,when the roasting temperature exceeds 850℃and the addition of manganese carbonate greater than 2.0,it will result in the vanadium-containing phase being encapsulated by silicate and other liquid-phase prod-ucts,resulting in lower vanadium leaching rate.The optimal conditions in this experiment were water-washing liquid-solid ratio of 10 mL/g,manganese carbonate addition(in terms of n(MnO)/n(V2O5))of 2.0,roasting time of 2 h,roasting temperature of 850℃,leaching time of 30 min and leaching temperature of 50℃.The leaching rate of vanadium under the above condi-tions reached 82.16%,and the leachate could obtain powdered vanadium pentoxide with purity greater than 99% after ammo-nium salt vanadium precipitation and roasting process.This process realizes the efficient extraction and separation of vanadium from vanadium-containing tailings of titanium tetrachloride refining,and the research results have guiding significance for vana-dium extraction from this type of tailings.

titanium tetrachloride refining tailingsthermodynamics calculationsmanganization roastingvanadium leac-hing rateV2O5

杨奇霖、卿海天、张杰、张志远、居殿春、张俊、堵伟桐

展开 >

江苏科技大学冶金工程学院,江苏 苏州 215600

中信钛业股份有限公司,辽宁 锦州 121000

钢铁研究总院先进钢铁流程及材料国家重点实验室,北京 100081

四氯化钛精制尾渣 热力学计算 锰化焙烧 钒浸出率 五氧化二钒

江苏省自然科学基金青年基金项目江苏省研究生科研与实践创新计划项目张家港市校企合作产学研前瞻性项目

BK20210888KYCX23_21912023Sk20200040

2024

金属矿山
中钢集团马鞍山矿山研究院 中国金属学会

金属矿山

CSTPCD北大核心
影响因子:0.935
ISSN:1001-1250
年,卷(期):2024.(1)
  • 10