绝缘材料2025,Vol.58Issue(1) :74-81.DOI:10.16790/j.cnki.1009-9239.im.2025.01.009

热老化对水轮发电机定子线棒端部主绝缘局部放电特性的影响

Effect of thermal ageing on partial discharge characteristics of main insulation at the end of hydro generator stator bar

陈科元 马山刚 金福宝 冷雪健
绝缘材料2025,Vol.58Issue(1) :74-81.DOI:10.16790/j.cnki.1009-9239.im.2025.01.009

热老化对水轮发电机定子线棒端部主绝缘局部放电特性的影响

Effect of thermal ageing on partial discharge characteristics of main insulation at the end of hydro generator stator bar

陈科元 1马山刚 2金福宝 2冷雪健2
扫码查看

作者信息

  • 1. 青海大学 能源与电气工程学院,青海 西宁 810016;国网陕西省电力有限公司商洛供电公司,陕西 商洛 726000
  • 2. 青海大学 能源与电气工程学院,青海 西宁 810016
  • 折叠

摘要

水轮发电机定子线棒端部主绝缘在长期运行过程中因温升及局部放电的高能粒子轰击极易发生热老化,劣化绝缘性能,加剧局部放电强度.文中根据水电站F级定子线棒绝缘结构设计制作了3种端部典型缺陷模型,在170℃环境条件下进行加速热老化;通过扫描电子显微镜和拉曼光谱分析仪对不同老化周期下的主绝缘试样进行形貌结构和分子结构分析,揭示主绝缘材料——环氧玻璃粉云母带的热老化机理;搭建局放试验平台,采用脉冲电流法和臭氧检测法测量老化前后放电量和放电次数及臭氧浓度的变化情况,并挖掘其对端部缺陷局部放电特性的影响规律.结果表明:加速热老化周期与主绝缘材料绝缘结构变化成正比,老化时间越长,试样表面越粗糙;热老化会破坏环氧玻璃粉云母带的分子链结构,苯环等芳香族和碳环上的C-C键及C=C键特征峰变化与绝缘电阻具有相关性;热老化对内部气隙放电量和放电次数的影响较小,对防晕层脱落缺陷的低放电量次数影响较大;不同绝缘缺陷模型臭氧的饱和浓度和饱和时间存在较大差异,热老化前不同放电类型的臭氧浓度变化具有阶段性,而热老化后臭氧浓度无明显的阶段性增长特征.

Abstract

The main insulation of hydro generator stator bar ends is susceptible to thermal ageing due to temperature rise and bombardment of high-energy particles from partial discharges during long-term operation,which would deteriorate the insulation performance and intensify the partial discharges.In this paper,three kinds of typical end defect models were made according to the insulation structure of F-class stator bar for hydropower station,and accelerated thermal ageing tests were carried out at 170℃.The morphological structure and molecular structure of the main insulation samples under different ageing cycles were analyzed by scanning electron microscope and Raman spectrometer to reveal the thermal ageing mechanism of main insulating material,which is epoxy glass mica tape.A partial discharge test platform was set up,the changes of discharge amount,discharge number,and ozone concentration before and after ageing were measured by the pulse current method and ozone detection method,and their influence law on the partial discharge characteristics of end defects were explored.The results show that the accelerated thermal ageing cycle is proportional to the insulating structure change of the main insulating material,and the longer the ageing time,the rougher the surface of the samples.Thermal ageing destroys the molecular chain structure of the epoxy glass mica tape,and the characteristic peak changes of C-C bond and C=C bond on the benzene ring and other aromatic and carbon rings have correlation with the insulation resistance.Thermal ageing has a small effect on the discharge amount and discharge number of the internal air gap,and has a large effect on the discharge number of low discharge amount of the anti-corona layer shedding defects.The saturation concentration and saturation time of ozone in different insulation defect models have large differences,and the changes of ozone concentration of different discharge types before ageing have stage growth characteristics,while the ozone concentration after ageing has no obvious stage growth characteristics.

关键词

热老化/定子线棒/局部放电/环氧玻璃粉云母带

Key words

thermal ageing/stator bar/partial discharge/epoxy glass mica tape

引用本文复制引用

出版年

2025
绝缘材料
桂林电器科学研究院

绝缘材料

北大核心
影响因子:0.809
ISSN:1009-9239
段落导航相关论文