首页|亚硫酸钠还原法和混凝组合工艺处理磷化工废水工程实例

亚硫酸钠还原法和混凝组合工艺处理磷化工废水工程实例

A Project Case of Phoschemical Industrial Wastewater Treatment by the Combined Process of Sodium Sulfite Reduction and Coagulation Combination Process

扫码查看
磷化工废水中含有浓度较高的次氯酸根和磷酸根, 不能直接排放, 国内有关磷化工废水处理的文献报道较少.在此介绍某磷化工厂生产废水处理工程实例.根据磷化工废水水质特点, 江苏江南环境工程设计院采用混凝和亚硫酸钠还原组合工艺对其进行处理, 总磷、COD平均进水浓度为85 mg/L、395 mg/L, 与此对应, 出水平均浓度分别低于0.5 mg/L、100 mg/L.实践表明, 该组合工艺处理效果较好, 达到《污水综合排放标准》GB8978-1996中一级标准.
Phoschemical industrial wastewater contained high concentration of hypochlorite and phosphate, which could not be directly discharged. There were few reports on the wastewater treatment in China. Here was an example of the project. According to the characteristics of the wastewater quality, we treated it with a sodium sulfite reduction and coagulation combination process. The average concentrations of total phosphorus and COD in influent were 85 mg/L and 395 mg/L. Corresponding to this, the average concentration of total phosphorus and COD in effluent were lower than 0. 5 mg/L and 100 mg/L. The practice showed that the combined process had a good treatment effect, and the effluent quality parameters reached the requirements of grade I standard in Integrated Wastewater Discharge Standard (GB8978-1996).

Phoschemical industrial wastewaterPhosphateHypochloriteSodium sulfite

汪佛松、冯敏

展开 >

江苏江南环境工程设计院有限公司,江苏南京 210000

磷化工废水 磷酸根 次氯酸根 亚硫酸钠

2018

污染防治技术
中国环境科学学会 江苏省环境科学学会

污染防治技术

ISSN:
年,卷(期):2018.31(4)
  • 3
  • 2