首页|Al?Mg?Si合金在低温下的流变行为和断裂

Al?Mg?Si合金在低温下的流变行为和断裂

扫码查看
原文链接
  • NETL
  • NSTL
  • 万方数据
  • 维普
研究AA6061合金的拉伸和断裂行为,为该合金在低温范围内的拉伸和断裂行为提供定量数据.在298 K、173 K和77 K下对铝合金进行固溶处理,然后在应变速率为0.1～0.0001 s−1条件下进行拉伸试验.结果表明,77 K时Portevin−Le Chatelier(PLC)效应和动态应变时效(DSA)被抑制.相反,298 K时,观察到PLC效应的特征,即明显的锯齿状流变.77 K固溶处理后样品的拉伸性能与173 K和298 K处理的样品拉伸性能相比,强度、伸长率、韧性模量、应变硬化指数和应变速率敏感性同时提高,这与低温下动态回复速率的降低有关.与之相对应,断口形貌结果显示,77 K处理的样品韧窝尺寸减小,而韧窝覆盖的面积增加.173 K和77 K处理的样品中DSA被抑制,其实验结果与Johnson−Cook模型模拟结果吻合较好.
Flow behavior and fracture of Al−Mg−Si alloy at cryogenic temperatures
The tensile and fracture behaviors of AA6061 alloy were investigated in order to provide quantitative data about this alloy at cryogenic temperatures. Specimens of AA6061 alloy were solution heat treated before tensile tests at 298, 173 and 77 K and tested at strain rates in the range from 0.1 to 0.0001 s−1. The results indicate the suppression of the Portevin−Le Chatelier (PLC) effect and dynamic strain aging (DSA) at 77 K. In contrast, at 298 K, a remarkable serrated flow, characteristic of the PLC effect, is observed. Furthermore, the tensile behavior at 77 K, compared with that observed at 173 and 298 K, shows a simultaneous increase in strength, uniform elongation, modulus of toughness, strain-hardening exponent and strain rate sensitivity, which is related to a decrease in the dynamic recovery rate at low temperature. These responses are reflected on the fracture morphology, since the dimple size decreases at 77 K, while the area covered by dimples increases. Comparisons of the Johnson−Cook model show that a good agreement can be obtained for tests at 173 and 77 K, in which DSA is suppressed.

cryogenic temperaturealuminum alloyflow behaviorstrain rate sensitivitywork-hardening behaviorJohnson−Cook modelfracture

Danielle Cristina Camilo MAGALH?ES、Andrea Madeira KLIAUGA、Vitor Luiz SORDI

展开 >

Department of Materials Engineering,Federal University of São Carlos−UFSCar,Rod. Washington Luiz,km 235,13565-905,São Carlos–SP,Brazil

低温 铝合金 流变行为 应变速率敏感性 加工硬化行为 Johnson−Cook模型 断裂

We would like to acknowledge the S?o Paulo Research Foundation (FAPESP)We would like to acknowledge the S?o Paulo Research Foundation (FAPESP)Conselho Nacional de Desenvolvimento Científico e Tecnológico - Brazil (CNPq)This study was financed in part by the Coordena??o de Aperfei?oamento de Pessoal de Nível Superior - Brazil (CAPES) - Finance Co

2014/ 15091-72016/10997-0449009/ 2014-9153181/2013-3

2021

10.1016/S1003-6326(21)65522-X

中国有色金属学报(英文版)
中国有色金属学会

中国有色金属学报(英文版)

CSTPCDCSCDSCI
影响因子：1.183
ISSN：1003-6326
年,卷(期)：2021.31(3)
  • 1
  • 2