首页|Microstructure- and cooling/lubrication environment-dependent machining responses in side milling of direct metal laser-sintered and rolled Ti6Al4V alloys

Microstructure- and cooling/lubrication environment-dependent machining responses in side milling of direct metal laser-sintered and rolled Ti6Al4V alloys

扫码查看
原文链接
  • NSTL
  • Elsevier
Ti6Al4V manufactured by direct metal laser sintering (DMLS) is a difficult-to-cut material and has a different microstructure to conventional Ti6Al4V. Therefore, this work aims to investigate the influence of microstructure characteristic and sustainable cooling/lubrication method on machining responses of Ti6Al4V. Side milling tests were performed under dry and supercritical CO2-based minimum quantity lubrication (scCO(2)-MQL) conditions. Experimental materials were DMLS-produced Ti6Al4V and conventional rolled one. Milling force, subsurface microstructure evolution, crystallographic texture, and residual stress were evaluated. For DMLS Ti6Al4V, subsurface plastic deformation depth increased with increasing cutting speed v(c). Only under the most drastic condition (highest v(c) = 180 m/min, dry milling), a white layer with grain refinement down to 0.4 mu m was formed, which resulted from alpha ->beta phase transformation and twinning-induced dynamic recrystallization. The activated twinning within the grain refinement layer was {10 (1) over bar2} not approximate to <(1) over bar 011 > and {10 (1) over bar1}<(1) over bar 012 > twinning. For conventional Ti6Al4V, in contrast, no subsurface microstructure evolutions were identified after milling. Milled surface of rolled Ti6Al4V exhibited residual tensile stresses while DMLS Ti6Al4V exhibited residual compressive stresses. Milling force of rolled alloy was 15 % higher than DMLS-produced one. The different cutting responses of the two alloys are attributed to the fact that rolled Ti6Al4V has fine-grained microstructures while DMLS alloy has coarse-grained microstructures. The proposed scCO(2)-MQL method can improve machinability and surface integrity, and suppress the activation of high order twinning of DMLS Ti6Al4V. This study's findings may be useful in developing finite element or analytical models for predicting the microstructural variations of DMLS Ti6Al4V during cutting.

MillingTi6Al4VDirect metal laser sintering (DMLS)RolledMicrostructure evolutionSupercritical CO2-based minimum quantity lubrication (scCO(2)-MQL)SUPERCRITICAL CARBON-DIOXIDESURFACE INTEGRITYMECHANICAL-PROPERTIESCUTTING FLUIDSTOOL WEARMACHINABILITYDRYSTRATEGIESCOOLANTSLM

Cai, Chongyan、An, Qinglong、Ming, Weiwei、Chen, Ming

展开 >

Shanghai Jiao Tong Univ

2022

10.1016/j.jmatprotec.2021.117418

Journal of Materials Processing Technology

Journal of Materials Processing Technology

EISCI
ISSN：0924-0136
年,卷(期)：2022.300
  • 3
  • 51