ZJ19型卷烟机平准器特征参数的建立
Establishment of the Characteristic Parameter about Ecreteur Dise of ZJ19 Cigarette-rolling Machine
齐延鹏 1丁康钟 1何蓉 1李曦 2黄治 1刘华 1俞海军 1周学政1
作者信息
- 1. 重庆中烟工业有限责任公司,重庆400060
- 2. 重庆中烟工业有限责任公司涪陵卷烟厂,重庆400810
- 折叠
摘要
为研究ZJ19卷烟机平准器与卷烟空头率的关系,采用正交设计方法,对平准器关键参数进行了研究,测定了卷烟机空头率和烟支烟丝密度.研究结果表明:在试验范围内,平准器深槽深度对卷烟机空头率影响最大,烟支重量和浅槽深度影响相对较小;烟支端头O～5mm烟支烟丝密度与卷烟机空头率之间相关性最高,可以用来评价烟支端部的紧实程度;建立了平准器深槽深度和浅槽深度的平准器特征参数k,该模型相关系数达0.943.验证结果表明,平准器特征参数k与烟端头O～5mm密度和卷烟机空头率具有高度相关性.
Abstract
To research the relationship between loose-end ratio of cigarettes and ecreteur disc type in 7J19 cigarettes maker,orthogonal design was applied on research of ecreteur disc parameters.Cut tobacco density and loose-end ratio of cigarettes were measured.The result showed:Within the scope of the set,deep groove depth has the greatest effect on loose-end ratio of cigarettes,single cigarette weight and shallow groove depth is relatively small;The density of 0 to 5 mm end of cigarettes showed highest correlation with loose-end ratio of cigarettes,so it can be used to evaluate the tight degree of cigarettes end;The characteristic parameter k was established about deep groove depth and shallow groove depth.The model correlation coefficient reached up to 0.943.Verification results showed that the characteristic parameter k had high correlation with the density of 0 to 5 mm end of cigarette and loose-end ratio of cigarettes.
关键词
ZJ19卷烟机/平准器/正交设计/特征参数Key words
ZJ19 cigarettes maker/Ecreteur dise/Orthogonal design/Characteristic parameter引用本文复制引用
出版年
2017
国家科技期刊平台
NSTL
维普
万方数据