光固化3D打印制备高性能BaTiO3压电陶瓷
Preparation of High-Performance BaTiO3 Piezoelectric Ceramics by Stereolithography 3D Printing
毕鲁南 1李伶 1宋涛 1王营营 1吕佳琪 1路翔 1韩卓群 2汪洋2
作者信息
- 1. 山东工业陶瓷研究设计院有限公司,淄博 255035
- 2. 济南大学材料科学与工程学院,济南 250024
- 折叠
摘要
光固化3D打印技术在制备异形压电陶瓷方面具有广阔的应用前景.本文采用数字光处理技术制备了钛酸钡(BaTiO3)压电陶瓷,研究了坯体形貌、烧结温度对钛酸钡微观结构的影响.结果表明,曲拉通X-100的引入使陶瓷料浆的黏度小于3 Pa·s,同时陶瓷粉体的引入未改变树脂的性质.陶瓷坯体层间结合良好,且无明显缺陷.烧成后的BaTiO3陶瓷内部含有四方与正交两种晶相,剩余极化强度为27.6 μC/cm2,矫顽场为4.6 kV/cm,相对介电常数为2 512,介电损耗为0.009 1,居里温度为167 ℃,介电常数为182 pC/N.
Abstract
Stereolithography 3D printing technology has broad application prospects in the preparation of special-shaped piezoelectric ceramics.In this paper,barium titanate(BaTiO3)piezoelectric ceramics were prepared by digital light processing technology.The effects of green body morphology and sintering temperature on the microstructure of barium titanate were studied.The results show that the introduction of Triton X-100 makes the viscosity of ceramic slurry less than 3 Pa·s,and the introduction of ceramic powder does not change the properties of resin.The bonding between the layers of ceramic green body is good,and there are no obvious defects.The BaTiO3 ceramics after sintering contains tetragonal and orthorhombic phases.The remanent polarization is 27.6 μC/cm2,the coercive field is 4.6 kV/cm,the relative dielectric constant is 2 512,the dielectric loss is 0.009 1,the Curie temperature is 167℃,and the dielectric constant is 182 pC/N.
关键词
钛酸钡/压电陶瓷/数字光处理技术/增材制造/铁电性能/介电性能Key words
barium titanate/piezoelectric ceramics/digital light processing technology/additive manufacturing/ferroelectric property/dielectric property引用本文复制引用
基金项目
山东省重点研发计划竞争性创新平台项目(2022XPT003)
出版年
2024
国家科技期刊平台
NSTL
万方数据