Influence of layer thickness on formation quality,microstructure,mechanical properties,and corrosion resistance of WE43 magnesium alloy fabricated by laser powder bed fusion

扫码查看

原文链接

维普
万方数据

外文摘要：Laser powder bed fusion(L-PBF)of Mg alloys has provided tremendous opportunities for customized production of aeronautical and medical parts.Layer thickness(LT)is of great significance to the L-PBF process but has not been studied for Mg alloys.In this study,WE43 Mg alloy bulk cubes,porous scaffolds,and thin walls with layer thicknesses of 10,20,30,and 40 pm were fabricated.The required laser energy input in-creased with increasing layer thickness and was different for the bulk cubes and porous scaffolds.Porosity tended to occur at the connection joints in porous scaffolds for LT40 and could be eliminated by reducing the laser energy input.For thin wall parts,a large overhang angle or a small wall thickness resulted in porosity when a large layer thicknesses was used,and the porosity disappeared by reducing the layer thickness or laser energy input.A deeper keyhole penetration was found in all occasions with porosity,explaining the influence of layer thickness,geomet-rical structure,and laser energy input on the porosity.All the samples achieved a high fusion quality with a relative density of over 99.5％using the optimized laser energy input.The increased layer thickness resulted to more precipitation phases,finer grain sizes and decreased grain tex-ture.With the similar high fusion quality,the tensile strength and elongation of bulk samples were significantly improved from 257 MPa and 1.41％with the 10 pm layer to 287 MPa and 15.12％with the 40 μm layer,in accordance with the microstructural change.The effect of layer thickness on the compressive properties of porous scaffolds was limited.However,the corrosion rate of bulk samples accelerated with increasing the layer thickness,mainly attributed to the increased number of precipitation phases.

外文关键词：

Magnesium alloyWE43Laser powder bed fusionLayer thicknessProcess optimization

作者：

Bangzhao Yin、Jinge Liu、Bo Peng、Mengran Zhou、Bingchuan Liu、Xiaolin Ma、Caimei Wang、Peng Wen、Yun Tian、Yufeng Zheng

展开 >

作者单位：

State Key Laboratory of Tribology in Advanced Equipment,Beijing,100084,China

Department of Mechanical Engineering,Tsinghua University,Beijing 100084,China

Institute for Precision Medicine,Tsinghua University,Beijing,102218,China

Department of Orthopaedics,Peking University Third Hospital,Beijing 100191,China

Engineering Research Center of Bone and Joint Precision Medicine,Ministry of Education,Beijing 100191,China

Beijing AKEC Medical Co.,Ltd.,Beijing 102200,China

School of Materials Science and Engineering,Peking University,Beijing 100871,China

展开 >

基金：

National Key Research and Development Program of ChinaNational Natural Science Foundation of ChinaNational Natural Science Foundation of ChinaNational Natural Science Foundation of ChinaTsinghua Precision Medicine Foundation

项目编号：

2018YFE0104200518753105217527482172065

出版年：

2024

DOI：

10.1016/j.jma.2022.09.016

镁合金学报(英文)

ISSN：2213-9567

年,卷(期)：2024.12(4)