首页|泥水盾构高含水率超高黏粒含量废弃泥浆絮凝脱水试验研究

泥水盾构高含水率超高黏粒含量废弃泥浆絮凝脱水试验研究

Flocculation and Dehydration Experiment on Waste Slurry Produced by Slurry Shield Tunneling With High Water and Ultra-High Clay Particle Contents

扫码查看
针对江阴第二过江通道工程中泥水盾构产生的高含水率超高黏粒含量废弃泥浆泥水分离困难、处理效率低的问题,采用阴离子型聚丙烯酰胺(APAM)、聚合氯化铝(PAC)和聚合氯化铝铁(PAFC)3 种絮凝剂开展泥浆絮凝试验,研究不同絮凝剂的絮凝脱水效果,选取底泥等效含水率、界面沉降速率、上清液浊度、泥浆脱水率以及Zeta电位作为评价指标,分析絮凝剂类型、用量、复配形式等对絮凝效果的影响,并探讨不同絮凝剂的絮凝机制.试验结果表明:1)不同絮凝剂对应的泥浆脱水效果排序为APAM>PAFC+APAM≥PAC+APAM>PAFC≥PAC,上清液浊度去除效果排序为PAFC>PAC>PAFC+APAM>PAC+APAM>APAM;2)有机絮凝剂APAM的最适投加量与其分子量密切相关,且不同分子量APAM的极限脱水率不尽相同,药剂分子量保持在 1 200 万~1 400 万时,脱水效果最佳;3)PAFC+APAM复配絮凝剂对本依托工程中高含水率超高黏粒含量废弃泥浆调理效果最好,PAFC溶液和APAM溶液的最适投加量分别为33 g·L-1 和233 g·L-1,对应的PAFC和APAM干物质投加量分别为1.6 g·L-1 和0.466 g·L-1,在此条件下,泥浆 90 min脱水率为 29.6%,上清液浊度可降低至 62.0 NTU;4)复配絮凝剂的脱水效果主要由有机絮凝剂APAM长链的吸附架桥作用主导,对上清液浊度的去除主要与无机絮凝剂PAC和PAFC的电性中和作用相关.
A significant volume of waste slurry with high water content and ultra-high clay particle content is produced during slurry shield tunneling in the second Jiangyin cross-river tunnel project.The water and slurry are hard to separate,resulting in low separation efficiency.Hence,various flocculants are used for slurry flocculation experiments to investigate the effect on flocculation and dehydration.The equivalent water content of sediment as well as interface sedimentation rate,supernatant turbidity,slurry dehydration rate,and Zeta potential are selected as evaluation indices to study the influence of flocculant type,dosage,and composite form on its flocculation effect.Finally,the flocculation mechanism of different substances is preliminarily discussed.The results reveal the following:(1)The slurry dehydration effect of different flocculants is in the following order:APAM>PAFC+APAM≥PAC+APAM>PAFC≥PAC,whereas the order of turbidity removal effect is as follows:PAFC>PAC>PAFC+APAM>PAC+APAM>APAM.(2)The optimal dosage of organic flocculant APAM is closely related to its molecular weight,and the maximum rate of dehydration varies for APAMs with different molecular weights.The best dehydration effect is achieved when the molecular weight of the agent is maintained at 12-14 million.(3)The PAFC+APAM composite flocculant exhibits the best conditioning effect on the waste slurry with high water content and ultra-high clay particle content.In this research,the optimal dosages for PAFC and APAM solutions are 33 and 233 g·L-1,respectively,and the corresponding dosages of dry matter for PAFC and APAM are 1.6 and 0.466 g·L-1,respectively.Under this condition,the dehydration rate of the slurry is 29.6%after 90 min,and the turbidity of the supernatant can be reduced to 62.0 NTU.(4)The primary mechanism responsible for the dehydration effect of composite flocculants is the adsorption bridging effect of the long chain of the organic flocculant APAM.Meanwhile,turbidity removal is mostly associated with the electrical neutralization of the inorganic flocculants PAC and PAFC.

slurry shieldflocculationwaste slurryultra-high clay particle contenthigh water contentdehydration performance

豆留盼、王峻、李海涛、吴东阳、张心源、魏力峰

展开 >

西南交通大学 交通隧道工程教育部重点实验室,四川 成都 610031

江苏省交通工程建设局,江苏 南京 210004

泥水盾构 絮凝 废弃泥浆 超高黏粒含量 高含水率 脱水性能

国家自然科学基金四川省杰出青年基金

520784282020JDJQ0032

2024

隧道建设(中英文)
中铁隧道集团有限公司洛阳科学技术研究所

隧道建设(中英文)

CSTPCD北大核心
影响因子:0.785
ISSN:2096-4498
年,卷(期):2024.44(4)
  • 23